FAQ   Search   Memberlist  
Profile    Log in to check your private messages    Register    Log in
Virtual terminals corrupt display

 
Post new topic   Reply to topic    BLAG Forum Index -> support
View previous topic :: View next topic  
Author Message
kazim
PostPosted: Sun Oct 26, 2008 12:50 pm    Post subject: Virtual terminals corrupt display Reply with quote

Hi All,

While gnome works normally, my virtual terminals (CRTL-ALT F1-6) are showing up corrupt and unresponsive screens, display is inverted grey and coloured boxes (sometimes flashing bits) which reminds me a lot of when my Sinclair ZX81 used to crash from a dodgy for/next loop in pacman (happened a lot).

When I switch to the VTs looking like this, sound from mplayer inside gnome goes silent, but other tasks such as uploads/downloads/apache/logins go on normally.

On some VTs there looks like a cursor but although it responds to keystrokes it does respond as a normal VT prompt should.

Using CTRL-ALT-F7 does not resume the X11 terminal, however using ALT-RIGHT repeatedly seems to cycle through the messed up VTs, eventually reaching F7 and X11 resumes.

Fresh install of 9001. Any ideas?

Code:

[root@eff ~]# uname -a
Linux eff 2.6.25.10-libre.86.fc9.1.i686 #1 SMP Thu Jul 17 00:09:46 EDT 2008 i686 i686 i386 GNU/Linux


Thinkpad X60s, 90001, gnome.

Code:


[root@eff ~]# cat /etc/X11/xorg.conf
# Xorg configuration created by pyxf86config

Section "ServerLayout"
   Identifier     "Default Layout"
   Screen      0  "Screen0" 0 0
   InputDevice    "Keyboard0" "CoreKeyboard"
EndSection

Section "InputDevice"
# keyboard added by rhpxl
   Identifier  "Keyboard0"
   Driver      "kbd"
   Option       "XkbModel" "pc105"
   Option       "XkbLayout" "gb"
EndSection

Section "Device"
   Identifier  "Videocard0"
   Driver      "intel"
EndSection

Section "Screen"
   Identifier "Screen0"
   Device     "Videocard0"
   DefaultDepth     24

   SubSection "Display"
      Viewport   0 0
      Depth     24
   EndSubSection

   #this is for the external monitor on the tpad
   #see: http://www.jimmy.co.at/weblog/?p=73
   #SubSection "Display"
   #  Depth     16
   #  Modes "1024x768" "800x600" "640x480"  "1600x1200" "1280x1024" "1280x960"
   #   Virtual 2624 1968
   #EndSubSection
   # adjust resolution from command with:  xrandr --output VGA --right-of LVDS
   # xrandr --output VGA --off
   # xrandr --output VGA --mode 1600x1200

EndSection


weyasey
PostPosted: Sun Oct 26, 2008 8:08 pm    Post subject: Reply with quote

kazim wrote
Quote:
Fresh install of 9001. Any ideas?

Is this a fresh install from CD or net install/upgrade?

If it was a net install it is possible that there were failures and missing files, try using yum to reinstall gnome and xorg then set the run level to 5 and reboot. That is if you did a net install as for a CD fresh install I did not have any issues so it is possible that you have a corrupted installation media, burn a fresh CD and reinstall.


_________________
If it hurts it's because you're alive.
Display posts from previous:   
Post new topic   Reply to topic    BLAG Forum Index -> support
Page 1 of 1

Protected by Anti-Spam ACP